Round Prints

[Mr.Noßody]

A print brick from a 1x1 round brick.
Make a soup can.

Id think it would be made by now, and if it is, Hell, I cant find it...

[Ad Bot]

[Mr.Noßody]

If no one gets what I mean, I mean the print surface wraps around the cylinder brick like a label...

[Muffin]

I know what you mean. But i think it would come out a little weird.. like stretched. So it might not look very good.

[Mr.Noßody]

Well then, the dimensions should be pre-stretched right?

[Treynolds416]

Well then, the dimensions should be pre-stretched right?

Yep. Might require some math, so I don't think as many people would jump at the opportunity to make this...

[Mr.Noßody]

I bet your right, I guess Barrel prints will come in the far future if not ever...

[Treynolds416]

I bet your right, I guess Barrel prints will come in the far future if not ever...

Or you could use the barrel vehicle.

[tails]

2x2 was made:

http://forum.blockland.us/index.php?topic=74828.0

[Celtic Wolf]

2x2 was made:

http://forum.blockland.us/index.php?topic=74828.0

Good, you corrected it!

[Mr.Noßody]

Or you could use the barrel vehicle.

Yea, but then you have to build around it so you cant get in it..

Also, I do NOT mean prints on the TOPS of round bricks, I mean ON the round of the round bricks.
(I have that print plate too)

[Mr.Noßody]

Yep. Might require some math, so I don't think as many people would jump at the opportunity to make this...

Bit..by the time one of the correct dimensions for this print would be made, it would be easily editable. So the math only has to be done once...