SupercutPlace a selection box over some bricks, like this:
Then press shift-ctrl x to remove the selected parts:
For example, you can cut a door into a brick wall:
...after a lot of cuts into a 2x4 wall, it might look like this:
Some cool stuff you can make with this:
FillbricksPlace a selection box somewhere, like this:
Then press shift-ctrl v to place bricks inside the box:
It will use supercut to automatically make holes into existing bricks.
Fillbricks works with any size of box, though you probably shouldn't go crazy!
Version 1.5.0• Added supercut function: /superCut or shift-ctrl x in box selection mode
• Added fillBricks function: /fillBricks or shift-ctrl v in box selection mode
• Move/rotate the whole selection box by holding ctrl
• Fixed selection without volume flickering sometimes
Use the automatic updater if you can, otherwise download again from the first page.
If the updater does not show an update, run this command: Updater.checkForUpdates();
